INSTALLATION

INSTALLATION

1. The fuel saver must be installed on the fuel pipe after the fuel filter.
2. The fuel saver should be placed on the fuel pipe as close as possible to the point where the fuel pipe enters the engine block (injector head) or fuel injector.
3. The orientation of the fuel saver should be such that the round caps on each half of the fuel saver (with EPS 128 printed on them) should be on the right and left hand side of the fuel pipe rather than top and bottom of the fuel pipe.

When installing, simply clip the Fuel Saver on to the fuel line, after the fuel filter and as close as possible to the injector head. Secure the fuel saver in place (at both ends) using the cable ties provided.

NOTE: The fuel saver must be installed on the fuel line after the fuel filter. It should be placed on the fuel line as close as possible to the point where the fuel line enters the engine block (injector head).

The Guarantee

The EPS Fuel Saver offers a minimum of 12% - 15% reduction in your fuel bill from day 1. The amount of saving will increase  as the vehicle is driven and de-carbonised, which is usually about 400 miles after the installation of the fuel saver.

The amount of fuel saving also depends upon the usage pattern. On average our customers have genuinely seen the following savings:

• Minimum 12% - 15% savings from day 1 (in cities)
• 15% - 20% savings on long routes and motorways.